Related Experiment Video
Updated: Jul 12, 2025

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
Published on: May 30, 2014
Experimental demonstration of the quantum noise randomized cipher based on cascaded phase shift keying without a
Abstract:
To break the dependence on a high-speed and high-resolution digital-to-analog converter (DAC) in the traditional quantum noise randomized cipher (QNRC), a practical DAC-free modulation scheme based on cascaded phase-shift keying (PSK) is proposed and demonstrated by a proof-of-concept experiment. By employing seven cascaded phase modulators (PMs) driven by designed electrical voltage signals, a 128 PSK-QNRC system is achieved with a transmission rate of 10 Gbaud/s and a transmission distance more than 50 km, which eliminates the need for a DAC on the transmitter side. The bit error rate (BER) performance of the proposed scheme is compared to that of a traditional scheme based on an arbitrary waveform generator (AWG) with a sampling rate of 25 GSa/s. The results show that compared to a traditional scheme, the power penalties of the proposed scheme are -1.8d B, 0.9 dB, and 1 dB, respectively, at the rates of 10, 5, and 2.5 Gbps. In other words, the BER performance of the proposed scheme is close to the traditional scheme at a low transmission rate, but better than that of the traditional scheme at a high transmission rate, where the sampling rate of the DAC is not high enough to generate a complete waveform. This work greatly enhances the security of a QNRC system.
Related Concept Videos
Cascaded Op Amps
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
Amplifying Signals via Enzymatic Cascade
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Propagation of Uncertainty from Random Error
Phasor Arithmetics
When the derivative of a sinusoid is taken in the time domain, it transforms into its corresponding phasor multiplied by j-omega (jω) in the phasor domain, where j is the imaginary unit, and ω is the angular...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...

