Experimental and analytical investigation on forced and free vibration of sandwich structures with reinforced
Farshad Rahmani1, Reza Barbaz-Isfahani1,2, Saeed Saber-Samandari2,3
1Department of Mechanical Engineering, Amirkabir University of Technology, Tehran, Iran.
Abstract:
The main objective of this study is to investigate the impact of nanoparticles as reinforcement material on the vibrational behavior of sandwich structures in an acidic medium. The glass fiber reinforced polymer (GFRP) faces were fabricated with and without the addition of 3 wt% nanoclay and nanosilica to determine the mechanical behaviors of the GFRP faces in the presence of an acidic medium. The obtained results showed adding 3 wt% of nanoclay caused better durability and less mass variation of composite specimens in sulfuric acid. The "Coefficient of acidic immersion expansion" () is determined by measuring the length and mass variation of GFRP specimens in the immersion, and applied to low order piecewise shear deformation theory (LOPSDT) for the first time; Also the frequency results of LOPSDT have been shown good agreement in validation with the ANSYS numerical solution. It is shown that acidic environment reduces the frequency of the first mode of sandwich plates with reinforced face by 3 wt% nanosilica, and nanoclay has increased by 6.81 % and 4.66 %, respectively. This study indicates after one month of immersion, the natural frequency of the sandwich with pure, and 3 wt% nanoclay reduces about 1 %, and the natural frequency of the sandwich with the faces reinforced with 3 wt% nanosilica reduces by more than 3 %; Moreover, the frequency of forced vibrations, caused by acidic immersion expansion, was improved significantly by 10.04 % and 6.54 % in the first mode by incorporating 3 wt% of nanoclay, and nanosilica into the faces of the sandwich in one month of immersion compared to the sandwich with pure faces.
Related Concept Videos
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
Flexural Stress
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to...
Bending of Members Made of Several Materials
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each...
Residual Stresses in Bending
Fiber Reinforced Concrete
Non-destructive Tests for Concrete Strength


