Related Experiment Video
Updated: Jul 12, 2025

Collecting Sleep, Circadian, Fatigue, and Performance Data in Complex Operational Environments
Published on: August 8, 2019
Familiarization with ambulatory sleep and blood pressure monitoring is necessary for representative data collection
Kasey Kleiber1, Caroline J Smith1, Steven D Beck1
1Department of Public Health and Exercise Science, Appalachian State University, Boone, North Carolina, USA.
Abstract:
Ambulatory sleep and blood pressure monitoring are gaining popularity as these can be completed in an individual's home. Little is known regarding the reliability of data and the time it takes to acclimate to the equipment. This study aimed to determine how many nights of wearing the monitoring equipment were required to restore sleep architecture and blood pressure data to baseline. It was hypothesized familiarization would be demonstrated by night 3. Ten male and 10 female subjects completed three nights of sleep and blood pressure recordings. At visit 1, the subjects were familiarized with the equipment and instructed to wear the Sleep Profiler{trade mark, serif} and SunTech Medical Oscar2 ambulatory blood pressure cuff simultaneously for three consecutive nights, then subjects returned the equipment. The percent of time spent in rapid eye-movement (REM) sleep was statistically different on night 3 when compared to night 1. Wake-after-sleep onset and sleep latency were not statistically different between nights 1, 2, and 3. Systolic, diastolic, and pulse pressure were all significantly lower on night 3 compared to night 1. Cortical and autonomic arousals were statistically different on night 3. Ambulatory sleep and blood pressure monitoring need at least 3 nights for familiarization. The percent of time spent in REM sleep was statistically different on night 3 when compared to night 1. Systolic blood pressure, diastolic blood pressure, and pulse pressure were all significantly lower on night 3 compared to night 1. Cortical and autonomic arousals were statistically different on nights 3 and 2, respectively compared to night 1. Based on these findings, ambulatory sleep and blood pressure monitoring takes three nights before the data are reliable and the person is familiarized with the mode of measurement. Therefore, it is recommended to use at least three nights of data collection when using the Sleep Profiler and Oscar2 ambulatory blood pressure cuff in order for results to be valid and reliable.
Related Concept Videos
Errors occurring during blood pressure monitoring
Several factors...
Special considerations while measuring blood pressure
Monitoring Both Arms:
Monitoring BP in both arms during the initial assessment is advisable, as the systolic value may differ by five to ten mm Hg between arms. For subsequent BP assessments, use the arm with the higher reading.
Pre-Procedural Guidelines for Assessing Blood Pressure
Hypertension III: Clinical Manifestations and Diagnostic Studies
Measurement of Blood Pressure
Equipments Used To Measure Blood Pressure
This invasive approach involves cannulating a peripheral artery. During each cardiac contraction, pressure generates mechanical motion within the catheter, transmitted through rigid, fluid-filled tubing to a transducer. This transducer converts mechanical motion into electrical signals displayed as waveforms on a monitor. An automatic flushing system prevents blood backflow. Due to the potential risk of unexpected arterial blood loss, this method is primarily used in intensive...

