Effects of sodium sulfide concentration on the solid and solution chemistry of a biosolids slurry for phosphorus...

Municipal biosolids contain organic and inorganic phosphorus (P) that could be recovered for reuse as P fertilizer. Inorganic P compounds include iron phosphates that precipitate and/or adsorbed phosphate ions as a consequence of soluble iron addition in order not to exceed total phosphorus (TP) emission limits. The inorganic orthophosphate (o-Pi) minerals within biosolids can have low solubilities. One P recovery strategy is to maximize the dissolution of o-Pi from biosolids for reuse. Dissolving iron phosphates in biosolids by adding sodium sulfide was assessed as an o-Pi dissolution strategy. 10 % w/w biosolids slurries with a total phosphorus (TP) of 0.97 ± 0.03 mmol P/dry g were mixed with sulfide/TP (S^2-/TP) molar ratios from 0 to 4 for up to 96 h. The maximum o-Pi concentration (48 ± 7 mM, or 42 ± 6 % of TP) was obtained for 4 S^2-/TP after 24 h at room temperature (RT). Iron concentrations measured by colorimetry (ferrozine) reduced from 0.6 ± 0.1 mM to less than 0.01 mM (S^2-/TP > 1). X-ray diffraction and FTIR suggest that sulfide treatment preferentially dissolved amorphous o-Pi-containing solids, vivianite, and minerals with iron, aluminum, phosphate, sulfate, and other subsitutions. Poorly crystalline erdite (NaFeS₂ ·2H₂O) was detected in products after S^2-/TP treatment ratios ≥ 2. Incubation at RT or 37 °C did not affect the o-Pi concentrations for 0 or 4 S^2-/TP over 47 h. Sulfide addition could also increase the risk of construction material corrosion, and reduce the efficiency of P recovery by precipitation. There are disadvantages to using sulfide to dissolve o-Pi from biosolids as a potential P recovery process.