Experimental Study on the Impact of Hydrogen Injection Strategy on Combustion Performance in Internal Combustion...

Hydrogen is an ideal alternative fuel for internal combustion engines due to its fast combustion rate and near-zero carbon emissions. To further investigate the impact of the injection strategy on combustion performance under various excess air coefficients and loads, experimental methods were employed to systematically study injection timing, injection pressure, and dual injection. The results demonstrate that appropriately delaying hydrogen injection timing can improve the thermal efficiency by up to 2.6% and reduce NOx emissions of equivalent combustion by nearly 88%. While increasing the hydrogen pressure to 8 MPa does not directly enhance the thermal efficiency and emissions, it can reduce the injection pulse width by approximately 75%, allowing for more flexibility in delaying the injection timing. Delaying the secondary end of injection (SEOI) leads to a reduction of over 47% in NOx emissions for λ (excess air coefficient) values of 1.5 and 1.0. The combustion duration and ignition delay initially increase and then decrease with the delay in SEOI, depending on the movement state of the fuel jet. With the increase in secondary injection proportion (SIP), brake thermal efficiency increases by no more than 1%, but NOx is reduced by more than 43% for λ values of 1.5 and 1.0. In the case of ultralean conditions (λ = 2.3), increasing the SIP from 0 to 30% results in a nearly 14% increase in the peak heat release rate (HRR) and a 19% reduction in combustion duration.