Related Experiment Video
Updated: Jul 11, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Research on blasting mechanism and blasting effect of aqueous media in open pit coal mines
Xiaohua Ding1, Xin Liu1, Zhongchen Ao2
1School of Mines, China University of Mining and Technology, Xuzhou, 221116, China.
Abstract:
Surface coal mining procedures include piercing-blasting-mining and loading-transportation-discharging, blasting link exists due to the poor blasting effect leads to low loading efficiency, blasting dust caused by environmental pollution and other problems. In this paper, from the mechanical characteristics of the water medium, we analyze in detail the transferring effect, transducing effect and bubble pulsation phenomenon of the water medium in the blasting process. The results show that when the blasting medium is water medium, the maximum principal stress is 1.53 times that of air medium; the peak energy transfer can be up to 2.73 times that of air medium. With the help of TrueGrid/LS-DYNA finite element analysis software to simulate the dynamic process of blasting, the study of the maximum principal stresses around the hole, the top of the slope, the foot of the slope on the maximum principal stress changes, the results show that the maximum principal stresses around the hole, the top of the slope, the foot of the slope unit with the increase in the water content is gradually increasing trend. Finally, combined with the actual mine production conditions for blasting field test, water-mediated blasting dust reduction rate of 75%, the use of AHP-fuzzy comprehensive evaluation method of two groups of traditional dry hole blasting and three groups of water-mediated blasting comprehensive evaluation, the results show that the water-mediated blasting scores are higher than the traditional dry hole blasting, proving that the water-mediated blasting has a certain prospect of engineering applications.
Related Concept Videos
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Quarrying of Stone
One common method involves using a diamond belt saw to cut large blocks from the quarry face. These blocks can be about 50 feet long and 12 feet high. After the initial vertical cut, drilling is performed at the base of the...
Pumped Concrete
For direct-acting pumps, the concrete enters the pump via the inlet valve under the action of gravity and suction created by the movement of the piston. This concrete is then forced into the pipeline and out through the outlet valve by the forward movement...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Alkali Aggregate Reaction in Concrete

