Related Experiment Video

Updated: Jul 11, 2025

Rapid Manufacturing of Thin Soft Pneumatic Actuators and Robots
08:47

Rapid Manufacturing of Thin Soft Pneumatic Actuators and Robots

Published on: November 8, 2019

7.7K

Robotization of Three-Point Bending Mechanical Tests Using PLA/TPU Blends as an Example in the 0-100% Range

Julia Głowacka1,2, Łukasz Derpeński3, Miłosz Frydrych1,2

  • 1Centre for Advanced Technologies, Adam Mickiewicz University in Poznań, 10 Uniwersytetu Poznańskiego, 61-614 Poznań, Poland.

Materials (Basel, Switzerland)
|November 14, 2023
PubMed

Keywords:
AI feeding dataautomationflexural propertiesoptical microscopy (MO)polylactide (PLA)polymer blendsroboticsthermal analysisthermoplastic polyurethane (TPU)

More Related Videos

Author Spotlight: Enhancing Accuracy and Reproducibility in Whole Bone Bending Tests04:20

Author Spotlight: Enhancing Accuracy and Reproducibility in Whole Bone Bending Tests

Published on: September 1, 2023

870
A Coupled Experiment-finite Element Modeling Methodology for Assessing High Strain Rate Mechanical Response of Soft Biomaterials11:28

A Coupled Experiment-finite Element Modeling Methodology for Assessing High Strain Rate Mechanical Response of Soft Biomaterials

Published on: May 18, 2015

12.5K

Related Concept Videos

Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
101
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
90