Experimental Investigation of the Peel Strength of Artificial Leather and Polypropylene Specimens

This study investigates the surface properties and adhesive strength of polypropylene (PP) in order to enhance the bond between PP injection-molded specimens and polyvinyl chloride (PVC) synthetic artificial leather. Plasma, primer, and flame treatments were applied to the surface of each specimen prepared using the two types of injection molds. The surface morphology, surface roughness, and contact angle were analyzed, and peel-strength analyses and a morphological inspections of the peeled specimens were performed. The peeling strength of the PP injection molding was measured, followed by a morphological examination of the peeled specimens. The plasma and flame treatments improved the peel strength, and the plasma and flame treatments changed the rough exterior to a hydrophilic surface, improving the peel strength. In addition, the primer treatment exhibited a lower peel strength than did the other treatments. This confirmed the low adhesion of the primer to the hydrophobic PP surface. The outcomes of this study can be employed across a multitude of industries that require improved adhesion for PP injection molded products.