Improvement of the quantitativeness of the thermal desorption-GC/MS method and development of polystyrene certified reference material for the quantification of decabromodiphenyl ether (BDE 209) by using isotope dilution mass spectrometry

A polystyrene (PS) certified reference material (CRM) for the analysis of decabromodiphenyl ether (BDE 209) was issued. PS disk was prepared by injection molding of the mixture of versine PS and BDE 209. The certification of the PS CRM was conducted by two analytical methods with different sample preparation methods using isotope dilution mass spectrometry (IDMS). The certified value, w_CRM, was 978 mg/kg, and this value coincided with the regulation value of BDE 209 in the Restriction of Hazardous Substances directive (1000 mg/kg). The uncertainties related to certification, u_wmean, inhomogeneity, u_hom, and long- and short-term instability, u_sts and u_lts, respectively, were evaluated based on the mass fraction of BDE 209. The u_wmean, u_hom, u_sts, and u_lts were 0.0265, 0.0046, 0.0061, and 0.0099 (relative), respectively, and the expanded uncertainty for this CRM was determined as 57 mg/kg (coverage factor is 2). Additionally, the quantitative capability of the thermal desorption-gas chromatography/mass spectrometry (TD-GC/MS) method was evaluated. In TD-GC/MS, the analytical values of the developed CRM obtained by the external and internal standard methods with matrix-free calibrants were out of the range of the w_CRM (almost 10% larger or smaller), whereas those with matrix-matched calibrants agreed with the w_CRM. In contrast to these results, the analytical values obtained by TD-GC/MS using IDMS were consistent with the w_CRM no matter if matrix-free or matrix-matched calibrants were used. These results indicated that, for quantification of BDE 209 in PS, the trueness and precision of TD-GC/MS can be enhanced by applying IDMS without matrix-matched calibrants.