Related Experiment Video
Updated: Jul 11, 2025

Experimental Methods of Dust Charging and Mobilization on Surfaces with Exposure to Ultraviolet Radiation or Plasmas
Published on: April 3, 2018
Study of the strongest dust storm occurred in Uzbekistan in November 2021
Bakhriddin E Nishonov1, Bakhtiyar M Kholmatjanov2, Lev D Labzovskii3
1Hydrometeorological Research Institute, Center of Hydrometeorological Service of the Republic of Uzbekistan, 100052, Tashkent, Uzbekistan.
Abstract:
We studied and reconstructed a severe Central Asian dust storm of November 4, 2021, through high-resolution TROPOMI UVAI spaceborne observations, ground-based aerosol measurements, and Lagrangian particle modeling. The dust storm was caused by the front part of a cold polar anticyclone front from the Ural-Volga regions, which struck the central and eastern parts of Uzbekistan under favorable atmospheric conditions. Two plumes spread out, causing a thick haze to blanket the region. The most severe dust storm effects hit the capital of Uzbekistan (Tashkent) and the Fergana Valley, where the thick atmospheric dust layer dropped the visibility to 200 m. PM10 concentrations reached 18,000 µg/m3 (260-fold exceedance of the local long-term average). The PM2.5 concentrations remained above 300 µg/m3 for nearly ten days, indicating an extremely long-lasting event. The dust storm was caused by an extremely strong summer heatwave of 2021 in Kazakhstan with unprecedentedly high temperatures reaching 46.5 °C. The long-lasting drought dried up the soil down to 50 cm depth, triggering the soil cover denudation due to drying out vegetation and losing its moisture. This event was the worst since 1871 and considering the increasing aridity of Central Asia, the onset of potentially recurring severe dust storms is alarming.
Related Concept Videos
Precipitation Processes
Responses to Drought and Flooding
Precipitation and Co-precipitation
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Threats to Biodiversity

