Related Experiment Video
Updated: Jul 10, 2025

Using Neuron Spiking Activity to Trigger Closed-Loop Stimuli in Neurophysiological Experiments
Published on: November 12, 2019
Non-fragile output-feedback control for time-delay neural networks with persistent dwell time switching: A system
Jianping Zhou1, Xiaofeng Ma1, Zhilian Yan2
1School of Computer Science & Technology, Anhui University of Technology, Ma'anshan, 243032, Anhui, China.
Abstract:
This paper is concerned with non-fragile output-feedback control for time-delay neural networks with persistent dwell time (PDT) switching in a continuous-time setting. The main purpose is to design an output-feedback controller subject to gain fluctuations, guaranteeing both asymptotic stability and L2-gain of the closed-loop control system. To achieve reduced conservatism, the controller is formulated to depend not only on the system mode but also on a time scheduler constructed based on the PDT switching rule and minimum time span. A criterion for the asymptotic stability and L2-gain analysis is established through the application of the Gronwall-Bellman inequality and mathematical induction. Then, a numerically tractable design approach for the desired controller is proposed, utilizing a four-section piecewise time-dependent Lyapunov-Krasovskii functional and several nonlinearity decoupling techniques. For comparative purposes, a simple case, independent of the time scheduler, is also investigated, and the corresponding controller design approach is presented. Finally, a simulation example is given to illustrate the effectiveness and superiority of the proposed system mode and time scheduler dual-dependent controller design approach.
Related Concept Videos
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
Long-term Potentiation
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state...
Classification of Systems-II

