Application of the virtual-fit method for fixed complete denture cases designed on intraoral scans: Effect of cement...

To validate the virtual-fit alignment, analyze the impact of cement spacing on internal/marginal gaps, and correlate results with conventional trueness measures.

Four dental abutment models were scanned using an industrial reference scanner (one time each), Emerald S (three times each), and Medit i700 (three times each) intraoral scanners (IOS). On each IOS scan (n = 24), three complete-arch fixed frameworks were designed with 70 or 140 µm cement space with no marginal space (groups 70 and 140) and 70 µm with an additional 20 µm space, including the margin (group 70+20). Two types of alignment were performed by GOM Inspect software. The reference and IOS scans were aligned through a conventional iterative closest point algorithm (ICP) where the penetration of the two scans was permitted into each other (conventional trueness method). Second, the computer-aided designs were superimposed with the reference scan also using an ICP, but preventing the design from virtual penetration into the model (virtual-fit method). The virtual-fit algorithm was validated by non-penetration alignment of the designs with the IOS scans. Internal and marginal gap was measured between the design and the abutments. The difference between spacing groups was compared by Friedman's test. A statistical correlation (Spearman's Rho Test) was computed between the measured gaps and the conventional trueness method. A significant difference was accepted at p<0.05 after the Bonferroni correction.

The gaps deviated from the set cement space by 3-13 µm on IOS scans (validation of virtual-fit algorithm). The internal gap of the design on the reference scan was not affected by cement spacing (Emerald S, p = 0.779; Medit i700, p = 0.205). The marginal gap in groups 70 and 70+20 was significantly lower than in group 140 in Emerald S (p<0.05). In Medit i700, it was lower in the 70+20 group than in the group 70 (p<0.01) and in the group 140 (p<0.05). Some Medit i700 scans exhibited high marginal gaps within group 70 but not in groups 70 and 140. The measured gaps correlated significantly (r = 0.51-0.81, p<0.05-0.001) with the conventional trueness but were 2.6-4.6 times higher (p<0.001).

Virtual-fit alignment can simulate restoration seating. A 20 µm marginal and 90 µm internal spacing could compensate for scan errors up to several hundred micrometers. However, 140 µm internal spacing is counterproductive. The conventional trueness method could only partially predict framework misfit.

The virtual-fit method can provide clinically interpretable data for intraoral scanners. Emerald S and Medit i700 intraoral scanners are suitable for fabricating complete-arch fixed tooth-supported prostheses. In addition, a slight elevation of spacing at the margin could compensate for moderate inaccuracies in a scan.