Related Experiment Video
Updated: Jul 10, 2025

Vegetated Treatment Systems for Removing Contaminants Associated with Surface Water Toxicity in Agriculture and Urban Runoff
Published on: May 15, 2017
Effects of dissolved organic carbon on potentially toxic element desorption in stormwater bioretention systems
Abdullah Al-Amin1, Robert J Ryan1, Erica R McKenzie1
1Temple University, Department of Civil and Environmental Engineering, 1947 North 12 Street, Philadelphia, PA 19122, United States.
Abstract:
Stormwater runoff contains dissolved organic carbon (DOC) and potentially toxic elements (PTEs). Interactions between DOC and PTEs can impact PTE speciation and mobility, but are not fully understood. Soil samples were collected from a vegetated bioretention bed to investigate the effects of DOC (0, 15, and 50 mg-C/L) on the desorption of 10 PTEs captured by the soil media: Mn, Fe, Co, Cu, Zn, As, Cd, Sn, Sb, and Pb. In the absence of DOC, the desorbed PTE concentration from bioretention media into the aqueous phase ranking was as follows: Fe > Mn ∼ Zn > Cu > Pb > Sb > As > Co > Sn ∼ Cd. Increased DOC concentrations resulted in a reduction of the soil-water distribution coefficient (Kd) values. The greatest shift in Kd was observed for Cu and lowest for Sb. The PTE sorption capacities were lower for surficial soil samples (lower Kd) compared to the deep soil samples. Overall, the desorbed PTE (average midchannel 55.7 μg/g) fraction accounted for <1.1 % of the total extracted PTEs (5364 μg/g), and while this is a small percentage of the total, this is the fraction that is mobile. The extracted PTE fractions revealed that DOC reduced the organic matter-bound and carbonate-bound fractions. The PTE desorption trends suggest that reducing DOC in stormwater runoff could be an effective measure to mitigate the release of PTEs into the environment.
More Related Videos
Related Concept Videos
Factors Affecting Solubility
Bioremediation
Precipitation and Co-precipitation
Extraction: Advanced Methods
Coagulation
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...

