Related Experiment Video
Updated: Aug 5, 2026
Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants
Published on: May 23, 2020
Enhancing skeletal stability and Class III correction through active orthodontist engagement in virtual surgical
Selene Barone1, Lucia Cevidanes2, Felicia Miranda3
1Department of Health Sciences, School of Dentistry, Magna Graecia University of Catanzaro, Catanzaro, Italy.
Introduction:
Skeletal stability after bimaxillary surgical correction of Class III malocclusion was investigated through a qualitative and quantitative analysis of the maxilla and the distal and proximal mandibular segments using a 3-dimensional voxel-based superimposition among virtual surgical predictions performed by the orthodontist in close communication with the maxillofacial surgeon and 12-18 months postoperative outcomes.
Methods:
A comprehensive secondary data analysis was conducted on deidentified preoperative (1 month before surgery [T1]) and 12-18 months postoperative (midterm [T2]) cone-beam computed tomography scans, along with virtual surgical planning (VSP) data obtained by Dolphin Imaging software. The sample for the study consisted of 17 patients (mean age, 24.8 ± 3.5 years). Using 3D Slicer software, automated tools based on deep-learning approaches were used for cone-beam computed tomography orientation, registration, bone segmentation, and landmark identification. Colormaps were generated for qualitative analysis, whereas linear and angular differences between the planned (T1-VSP) and observed (T1-T2) outcomes were calculated for quantitative assessments. Statistical analysis was conducted with a significance level of α = 0.05.
Results:
The midterm surgical outcomes revealed a slight but significantly less maxillary advancement compared with the planned position (mean difference, 1.84 ± 1.50 mm; P = 0.004). The repositioning of the mandibular distal segment was stable, with insignificant differences in linear (T1-VSP, 1.01 ± 3.66 mm; T1-T2, 0.32 ± 4.17 mm) and angular (T1-VSP, 1.53° ± 1.60°; T1-T2, 1.54° ± 1.50°) displacements (P >0.05). The proximal segments exhibited lateral displacement within 1.5° for both the mandibular right and left ramus at T1-VSP and T1-T2 (P >0.05).
Conclusions:
The analysis of fully digital planned and surgically repositioned maxilla and mandible revealed excellent precision. In the midterm surgical outcomes of maxillary advancement, a minor deviation from the planned anterior movement was observed.
