Related Experiment Video
Updated: Jul 9, 2025

Laboratory-determined Phosphorus Flux from Lake Sediments as a Measure of Internal Phosphorus Loading
Published on: March 6, 2014
Internal loading of phosphorus in streams described by a Sediment-Water Exchange Model for Phosphorus (SWEMP): From
Toon van Dael1, Charlotte Vermeiren1, Erik Smolders1
1Division of Soil and Water Management, Department of Earth and Environmental Sciences, KU Leuven, Kasteelpark Arenberg 20 bus 2459, 3001 Leuven, Belgium.
Abstract:
The reaction of phosphorus (P) between sediments and water in streams strongly affects the surface water P concentrations. A new reactive transport model (SWEMP: Sediment-Water Exchange Model for Phosphorus) was developed to describe redox dependent P sorption in the sediment and vertical diffusive transport of solutes to the overlying stream. The model parameters were independently obtained to first predict P release in ten different sediment-water batch systems and in two flumes. Input parameters are the degree of P saturation of the sediment, its organic matter content, dissolved oxygen (DO) concentration and temperature. The dissolved P concentrations in the overlying waters ranged from 0.02 to 1.2 mg P L-1 in these systems and were correctly predicted by the model within, on average, a factor 1.3 (batch) or 1.1 (flume). The P flux from the sediment towards the overlying water increased with increasing sediment P:Fe ratio and respiration rates, and with decreasing DO and water pH. After validation of the model with experimental data, it was used to predict monthly P concentrations in Flemish rivers using the total P emission data, total discharge, average sediment properties and the monthly averaged water temperatures, DO concentrations and electric conductivity. The monthly average P concentrations oscillate annually between 0.24 and 0.73 mg P L-1 and predictions matched the long-term monitoring data within 10 % using only one adjustable parameter for the entire water system (N > 250,000). The model predicts that summer peaks in P are related to internal loading from the sediment under anoxic conditions rather than to emission-dilution effects, i.e. external input of P and/or its concentration at lower flow rates. This suggests that, surface water P concentrations can be lowered by enhanced DO in the water, the addition of Fe and Al rich binding agents to the sediments and by reducing P emissions.
Related Concept Videos
The Phosphorus Cycle
Factors Affecting Solubility
Typical Model Studies

