Related Experiment Video
Updated: Jul 9, 2025
Metal Corrosion and the Efficiency of Corrosion Inhibitors in Less Conductive Media
Published on: November 3, 2018
Influence of PODE1 additive into ethanol-gasoline blends (E10) on fuel properties and phase stability
Omar I Awad1,2,3, Bo Zhou4, Zhenbin Chen1
1School of Mechanics and Electronics Engineering, Hainan University, Haikou, China.
Abstract:
Polyoxymethylene dimethyl ethers (PODEn, n = 1-8) as an oxygenated fuel are a promising alternative fuel with a high oxygen concentration, a low C:H ratio, and no C-C bonds in their chemical structure. This could lead to smoke-free combustion. In this study, we chose to focus on PODE1 because of its lower cetane number, which makes it more suitable for use in spark ignition (SI) engines. However, its lower boiling point and octane number remain challenges. A low boiling point may lead to high vapour pressure and require storage and handling comparable to gaseous fuels. We investigated the effect of adding PODE1 to gasoline-ethanol blends (E10) on fuel properties, including distillation curve, octane number, phase stability, C/O/H ratio, heat of combustion, kinematic viscosity, and density. Our results showed that the blended fuels of E10 and PODE1 are stable up to 10 % PODE1, and there was no phase separation. Additionally, up to 10 % PODE1 additive had no significant side effect on the fuel properties of E10, particularly boiling point and octane number. Thus, work offers creative points by proposing a new candidate for additive fuel to gasoline-ethanol blends, which contributes to reducing the soot emission of GDI engines.
Related Concept Videos
02:14Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
02:18Conformations of Ethane and Propane
Staggered conformation is a low energy and more stable conformation with the C-H bonds on the front carbon placed at 60°dihedral angles relative to the C-H bonds on the back carbon, leading to a reduced torsional strain. In staggered...
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
02:35Ethers from Alkenes: Alcohol Addition and Alkoxymercuration-Demercuration
Ethers can also be prepared from alkenes through acid-catalyzed addition of alcohols and alkoxymercuration–demercuration.
Preparation of Ethers by Acid-Catalyzed Addition of Alcohol to Alkenes
The acid-catalyzed addition of alcohol to an alkene involves treating the alkene with an excess of alcohol in the presence of an acid catalyst to form an ether under suitable conditions. The hydrogen will add to the less substituted carbon so that the nucleophile can attack the more...
02:32Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of...
02:12Solvating Effects