A sensitive "off-on" electrochemiluminescence DNA sensor based on signal cascade amplification circuit and...

A sensitive "off-on" electrochemiluminescence (ECL) DNA sensor was constructed based on Exo III-assisted cascade amplification system. In the cascade amplification circuit, target DNA and Exo III cutting substrate were designed into an inverted T-shaped binding mode to form a stable DNA junction, thus effectively triggering Exo III digestion cycle. During the biosensor assembly process, ferrocene (Fc) and distance-dependent ECL resonance energy transfer (ECL-RET) and surface plasmon resonance (SPR) effects were introduced to regulate the ECL of semiconductor quantum dots (QDs). Carboxylated ZnCdSe/ZnS QDs were used as ECL signal probes and K₂S₂O₈ was coreactant, and the initial cathodic ECL signal of QDs was efficiently quenched through electron and energy transfer with Fc and ECL-RET with Au NPs, leaving the system in "off" state. After the products of cascade amplification were introduced into the electrode surface, the single-stranded DNA modified with Fc was displaced, and the distance between Au NPs and QDs became farther, resulting in a transition from ECL-RET to SPR, and then a significant ECL signal boost was achieved, turning the system into "on" state. The combination of efficient cascade amplification system and sensitive "off-on" ECL signal change mode enabled the biosensing platform to detect target DNA with high selectivity (able to distinguish single-base mutated DNA) and ultra-high sensitivity (limit of detection was 31.67 aM, S/N = 3), providing a new perspective for designing highly sensitive and programmable ECL biosensors.