Related Experiment Video
Updated: Jul 9, 2025

In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx
Published on: May 13, 2020
Electrostatic discharge induced degradation of optical-electrical properties and defect evolution of GaAs-based
Abstract:
GaAs-based oxide-confined vertical-cavity surface-emitting lasers (VCSELs) exhibit relatively low resistance against reliability-related damage. In order to gain a deeper understanding of the degradation and failure mechanism in oxide-confined VCSELs caused by electrostatic discharge (ESD)-induced defect proliferation, we investigated the effects of ESD stress on the degradation of optical-electrical characteristics and the evolution of defects in VCSELs under human body model test condition. The degradation threshold values for forward and reverse ESD pulse amplitudes were estimated to be 200 V and -50 V, respectively. Notably, VCSELs demonstrated greater sensitivity to reverse bias ESD compared to forward bias ESD. Analysis of optical emission and microstructure provided evidence that the device failure is attributed to an increase in ESD current density, leading to the multiplication of dark line defects (DLDs) originating from the edge of the device's oxide aperture. The formation of defects occurred suddenly in discrete events within small regions, rather than progressing gradually and uniformly. These defects propagated and led to damage across the entire active region. We believe that our results would be meaningful for improving the reliability of VCSEL in the future.
More Related Videos
06:57Theoretical Calculation and Experimental Verification for Dislocation Reduction in Germanium Epitaxial Layers with Semicylindrical Voids on Silicon
Published on: July 17, 2020
11:14Comprehensive Characterization of Extended Defects in Semiconductor Materials by a Scanning Electron Microscope
Published on: May 28, 2016
Related Concept Videos
Electrostatic Boundary Conditions in Dielectrics
Consider a case where both the mediums across a boundary are two different dielectric materials. Recall that the electric field and electric displacement are proportional and related through the material's...
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Schottky Barrier Diode
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...