Real-world tailpipe emissions from autorickshaws (3-wheelers) under heterogeneous traffic conditions

The current study aimed to measure real-world emissions of three-wheeled autorickshaws powered by CNG and parameters (such as speed, acceleration, air-fuel (A/F) ratio, and rpm) influencing 3-wheeler emission rates. Test vehicles manufactured under Bharat Standards BS-III and BS-IV were monitored for exhaust emissions in Delhi city using a portable exhaust emission measurement system (AVL Ditest Gas 1000). The average emission rates of CO, HC, and NO gases for on-road autorickshaws were found to be 0.015 ± 0.017, 0.003 ± 0.0017, and 0.007 ± 0.005 g/s, respectively. Further, the highest emission factor values of 3.98 g/km and 3.93 g/km were estimated for CO and HC+NO gases, respectively. These values were found to be 1.4-3.2 times higher than the respective BS emission norms (BS III-CO =1.25 g/km, HC+NO = 1.25 g/km; BS-IV-CO = 0.94 g/km and HC+NO = 0.94 g/km). In this study, it was observed that the driving pattern and emissions were affected by traffic characteristics, driver behavior (constant acceleration and deceleration), and vehicle characteristics. The air-fuel ratio (A/F) was found to correlate highly with emission rates, followed by acceleration/deceleration and speed. Further analysis found that more than 70% of the aggregated emissions were due to acceleration and deceleration, which contributed to nearly 70% of the travel time. This was followed by the breakdown of speed and emissions into different bins, which found that 20-30 kmph has a higher emission rate and 40-50 kmph bin has a lower emission rate.