Development and Validation of RP-HPLC Method for the Determination of Enoxaparin Sodium in Dry Injection Formulation

Enoxaparin sodium is an anticoagulant medication that is used as a blood thinning agent. It is mostly used for the treatment and prevention of deep vein thrombosis (DVT) and pulmonary embolism (PE). It is also used in certain surgeries and during pregnancy. For the treatment of acute coronary syndrome (ACS) and heart attacks, it may be used. Enoxaparin sodium was validated by the RP-HPLC method. A simple RP-HPLC method was developed in a single HPLC run in a dry powder injection formulation. All injections of HPLC sample were 20 μL volume. The chromatographic separation was completed in the isocratic mode. The used column was USP-L8 (250 mm × 4.6 mm) of BDS type of 10 μm meters in the same mobile phase throughout the analysis by using methanol and ultrapure water with a ratio of 7:93, respectively. The flow rate was 1.0 mL/min. The mobile phase was filtered through 0.45 μm filter paper, and isocratic elution was performed. The refractive index (RI) detector was used to analyze this sample. The specific peak of enoxaparin sodium was observed at 5:56 min. The calculated detection limit (LOD) was 0.351 ppm, and the calculated quantitation limit was 1.063 ppm. In repeatability of precision, the average calculated assay (%) was 100.85%, and the calculated RSD (%) was 0.01. In the accuracy test, the RSD (%) was 0.50, and the mean recovery (%) was 100.35. The system's suitability was within the limit. This newly developed method is proposed according to ICH guidelines, and rules and can be applied effectively for the exact estimation of enoxaparin sodium in injection formulation. This newly developed methodology is affordable in cost as long as less time is taken and the consumption of samples is in smaller quantities for every investigation. In medicinal chemistry, the USP (United States Pharmacopeia) and BP (British Pharmacopeia) are directly involved in production as well as in quality testing.