The generation of a fourth-harmonic probe and its application in Nomarski interferometry at Shengguang-II

In this work, a design for the generation of a 4ω (263-nm) probe converted from a 1ω (1053-nm) laser is presented. The design is based on a beta-barium borate and potassium dihydrogen phosphate two-step frequency-conversion process. A suitable configuration for Nomarski interferometry based on the 4ω probe is proposed, for measuring the electron density of laser-produced plasmas. The signal-to-noise ratio of the output 4ω probe to 1ω and 2ω light after frequency quadrupling and harmonic separation is 103 with a 0.5 GW/cm2 1ω input but decreases to ∼102 at intensities below 0.1 GW/cm2. Additional noise suppression by a factor of 104 is achieved using filters before the interferometer recording camera. The spatial resolution of the diagnostic can reach 5.2 µm for a 10% modulation transfer function. An experiment validating the probe diagnostic system is conducted at the Shengguang-II laser facility. A clear interferogram of an aluminum plasma is obtained with 0.1 GW/cm2 input, suggesting a maximal electron density of about 2.5 × 1020 cm-3 as retrieved through an inverse-Abel transform. The design proposed in this paper is appropriate for a small laser device or a large laser facility that lacks a separate diagnostic beam, and it is an inexpensive solution as it requires small-aperture 1ω input at a relatively low intensity. All the key parameters necessary to implement the design are provided in detail, making it straightforward to reproduce or transplant the system for specific uses.