Accuracy of Instrument Portal Placement Using a Custom-Made 3D-Printed Aiming Device versus Free Hand Technique in...

While the insertion of the arthroscope into the elbow joint is relatively easy based on anatomical landmarks, obtaining a correctly located instrument portal is often difficult. Therefore, the goal of the study was to create a 3D-printed prototype of an aiming device for the guiding needle, and to check its feasibility. The study included fresh cadavers of 15 dogs, 9 males and 6 females, aged from 1 to 6 years (median 4 years) with body weight from 17 to 57 kg (median 30 kg). On each dog, we compared the number of attempts needed to obtain optimal direction of the guiding needle for the portal, using one elbow the prototype, and performing this as control on the opposite joint without the prototype (with a free hand). The number of attempts needed was significantly lower using the prototype (median 1) than on the control elbows (median 2, p = 0.009). The number of attempts was not correlated with the body weight neither in the case of experimental (R_s = 0.18, p = 0.532) nor control elbows (R_s = 0.13, p = 0.642). We conclude that the used prototype seems to be helpful in elbow joint arthroscopy.