Comparison between Micro-Powder Injection Molding and Material Extrusion Additive Manufacturing of Metal Powders for...

Original compositions based on iron micro-powders and an organic binder mixture were developed for the fabrication of sintered metallic elements with micro-powder injection molding (µPIM) and material extrusion additive manufacturing of metal powders (MEX). The binder formulation was thoroughly adjusted to exhibit rheological and thermal properties suitable for µPIM and MEX. The focus was set on adapting the proper binder composition to meet the requirements for injection/extrusion and, at the same time, to have comparable thermogravimetric characteristics for the thermal debinding and sintering process. A basic analysis of the forming process indicates that the pressure has a low influence on clogging, while the temperature of the material and mold/nozzle impacts the viscosity of the composition significantly. The influence of the Fe micro-powder content in the range of 45-60 vol.% was evaluated against the injection/extrusion process parameters and properties of sintered elements. Different debinding and sintering processes (chemical and thermal) were evaluated for the optimal properties of the final samples. The obtained sintered elements were of high quality and showed minor signs of binder-related flaws, with shrinkage in the range of 10-15% for both the injection-molded and 3D printed parts. These results suggest that, with minor modifications, compositions tailored for the PIM technique can be adapted for the additive manufacturing of metal parts, achieving comparable characteristics of the parts obtained for both forming methods.