Physical Artificial Arterial Pulse System for Development and Testing of PPG-Based Sensors

A physical system to generate a PPG-mimicking signal was designed and validated using everyday low-cost components to aid in medical sensor design. The pulse waveform was created by driving a working fluid into a silicone tube and changing the pressure within it. The corresponding waveform mimics a PPG signal through an artery, is adaptable, and repeatable. The working fluid is interchangeable allowing for change of blood analyte concentrations for development and testing of PPG-based sensors. The system was validated by black ink water compared to water and air compared to water testing to confirm optical transparency of the tube. The produced PPG signal, pulse rate and pressure change were compared to that seen in subjects. Optical transparency for 660 nm - 1550 nm wavelengths of light was validated with the signal, pulse rate and total compliance matching subject data. Thus, the system can mimic arterial pulses, creating a valid PPG signal that can be detected by PPG-based sensors.Clinical Relevance- Provides a low-cost, adaptable, physical PPG signal generator for research and development of optical medical sensor technologies.