Tocilizumab degradation via photo-catalytic ozonation process from aqueous

Following the advent of the coronavirus pandemic, tocilizumab has emerged as a potentially efficacious therapeutic intervention. The utilization of O₃-Heterogeneous photocatalytic process (O₃-HPCP) as a hybrid advanced oxidation technique has been employed for the degradation of pollutants. The present study employed a solvothermal technique for the synthesis of the BiOI-MOF composite. The utilization of FTIR, FESEM, EDAX, XRD, UV-vis, BET, TEM, and XPS analysis was employed to confirm the exceptional quality of the catalyst. the study employed an experimental design, subsequently followed by the analysis of collected data in order to forecast the most favorable conditions. The purpose of this study was to investigate the impact of several factors, including reaction time (30-60 min), catalyst dose (0.25-0.5 mg/L), pH levels (4-8), ozone concentration (20-40 mMol/L), and tocilizumab concentration (10-20 mg/L), on the performance of O₃-HPCP. The best model was discovered by evaluating the F-value and P-value coefficients, which were found to be 0.0001 and 347.93, respectively. In the given experimental conditions, which include a catalyst dose of 0.46 mg/L, a reaction time of 59 min, a pH of 7.0, and an ozone concentration of 32 mMol/L, the removal efficiencies were found to be 92% for tocilizumab, 79.8% for COD, and 59% for TOC. The obtained R² value of 0.98 suggests a strong correlation between the observed data and the predicted values, indicating that the reaction rate followed first-order kinetics. The coefficient of synergy for the degradation of tocilizumab was shown to be 1.22. The catalyst exhibited satisfactory outcomes, but with a marginal reduction in efficacy of approximately 3%. The sulfate ion (SO₄^2-) exhibited no influence on process efficiency, whereas the nitrate ion (NO₃^-) exerted the most significant impact among the anions. The progress of the process was impeded by organic scavengers, with methanol exhibiting the most pronounced influence and sodium azide exerting the least significant impact. The efficacy of pure BiOI and NH₂-MIL125 (Ti) was diminished when employed in their pure form state. The energy consumption per unit of degradation, denoted as EEO, was determined to be 161.8 KWh/m³-order.