Incongruent dissolution of silicates and its impact on the environment: an example of a talc mine

The paper analyzes the process of incongruent dissolution of silicates taking place in close proximity to a talc mine. The chemical and phase composition as well as the concentrations and mobility of potentially toxic elements (PTE) in research material with varying levels of weathering were determined using instrumental (XRF, XRD) and chemical methods (extractions: BCR, aqua regia, water leaching, 0.05 M EDTA). It was demonstrated that the predominant minerals in the weathering crust include weathering-resistant minerals (i.e. quartz and muscovite) and secondary minerals (kaolinite, illite and interstratified minerals, vermiculite/chlorite) and that the predominant processes are hydrolysis and oxidation. The weathering process has an impact on the complexity of the chemical and mineral composition and the diverse structure of the weathering crust. A layer of Fe and Al oxides and hydroxides forms in the upper part of the weathering crust, while the amount of silica decreases. Low-mobility elements (i.e. Si, Al and Fe) react on the phase separation surface, causing the formation of clay minerals (i.e. vermiculite, montmorillonite) or Al and Fe hydroxides (e.g. goethite). The duration of weathering causes an increase in the content of PTEs in solid materials: multifold in the case of Cr (15), Ba (9), Pb (7), Zn (6) and considerably lower in the case of V (1.3), Sr (0.8) and Co (0.4). It was demonstrated that PTEs co-occur in several chemical fractions in the weathering crust and that the highest share of their total concentration are cations incorporated in the crystal lattice of minerals and bound by strong crystalline bonds (F4 46%). The lowest share was observed for the reducible fraction (9%) and the share of the oxidizable fraction was 29% The most mobile cations connected by the weakest bonds comprised only 16% of the total concentration. Based on the content of the readily soluble fraction of PTEs, it was concluded that the degree of weathering does not increase the environmental risk, but actually reduces it for Cr, Cr and Pb. The obtained Ecological Risk Index (ERI) values indicate that the ecological risk associated with the elements tested is low for the entire area, which means that natural weathering processes do not have any impact on environmental pollution.