Features of Wax Appearance Temperature Determination of Waxy Crude Oil Using Attenuated Total Reflection Fourier...

The wax appearance temperature (WAT), being one of the key characteristics of waxy crude oil and other waxy substances, is used for the necessary assessment of the phase stability of materials during various technological processes. However, the determination of this parameter as well as peculiarities of wax formation under high gas pressure suffers from the lack of suitable techniques for this task. To address this issue, an attenuated total reflection Fourier transform infrared spectroscopy (ATR FT-IR) method has been applied for the first time to measure the WAT of waxy crude oil under high gas pressure. Carbon dioxide (CO₂), nitrogen, and natural gas were used in the study due to their widespread applicability as injection gases in enhanced oil recovery methods. The S2/S1 versus temperature method based on changes in the band of rocking vibrations of the CH₂ group was applied to determine WAT. It was found that the ATR FT-IR method based on the proposed dependence S2/S1 versus temperature gives lower WAT values compared to those observed by viscometry, magnetic resonance imaging inspection, and cross-polarized microscopy methods for the waxy crude oil studied. A detailed analysis was carried out using variable-temperature ATR FT-IR spectra of waxy crude oil in the temperature region near the WAT. Essentially different dynamics of wax crystal formation in waxy oil sample and model paraffin solution were demonstrated during the cooling process. The results obtained by high-pressure ATR FT-IR showed that CO₂ and natural gas reduce the WAT, while nitrogen has virtually no effect. In addition, for the studied oil, it was found that high pressure of CO₂ and natural gases leads to a visual decrease in the amount of wax crystals precipitated, but not to the complete disappearance of microcrystals at a certain temperature and pressure. The results obtained proved that ATR FT-IR can be an effective method for proper determinations of WAT under high-pressure conditions similar to those met in practice.