Efficient nitrite accumulation in partial sulfide autotrophic denitrification (PSAD) system: insights of S/N ratio,...

To provide the necessary nitrite for the Anaerobic Ammonium Oxidation (ANAMMOX) process, the effect of nitrite accumulation in the partial sulfide autotrophic denitrification (PSAD) process was investigated using an SBR reactor. The results revealed that the effectiveness of nitrate removal was unsatisfactory when the S/N ratio (mol/mol) fell below 0.6. The optimal conditions for nitrate removal and nitrite accumulation were achieved within the S/N ratio range of 0.7-0.8, resulting in an average Nitrate Removal Efficiency (NRE) of 95.84%±4.89% and a Nitrite Accumulation Rate (NAR) of 75.31%±6.61%, respectively. It was observed that the nitrate reduction rate was three times faster than that of nitrite reduction during a typical cycle test. Furthermore, batch tests were conducted to assess the influence of pH and temperature conditions. In the pH tests, it became evident that the PSAD process performed more effectively in alkaline environment. The highest levels of nitrate removal and nitrite accumulation were achieved at an initial pH of 8.5, resulting in a NRE of 98.30%±1.93% and a NAR of 85.83%±0.47%, respectively. In the temperature tests, the most favourable outcomes for nitrate removal and nitrite accumulation were observed at 22±1 ℃, with a NRE of 100.00% and a NAR of 81.03%±1.64%, respectively. Moreover, a comparative analysis of 16S rRNA sequencing results between the raw sludge and the sulfide-enriched culture sludge sample showed that Proteobacteria (49.51%) remained the dominant phylum, with Thiobacillus (24.72%), Prosthecobacter (2.55%), Brevundimonas (2.31%) and Ignavibacterium (2.04%) emerging as the dominant genera, assuming the good nitrogen performance of the system.