Related Experiment Video
Updated: Jul 7, 2025

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers
Published on: December 27, 2012
CPA-induced Hz to THz broadband absorber with switchable perfect absorption between radio-microwave and THz frequency
Mohd Salman Khan1, Pushpa Giri1, Gaurav Varshney1
1ECE Department, National Institute of Technology Patna, 800005, India.
Abstract:
The coherent perfect absorption (CPA) occurring in the graphene sheet suspended in air can be utilized to develop an ultrathin, ultra-broadband absorber working in the frequency range from a few hertz (Hz) to terahertz (THz) with perfect absorption. A graphene sheet is studied to induce the CPA to cover radio, microwave and lower THz frequency ranges. A graphene resonator able to provide the surface plasmon resonance (SPR) is combined with the graphene sheet to provide CPA at either side of a thin dielectric layer forms metamaterial structure with the cavity and enhances the absorption bandwidth in the THz region by creating a resonance near quasi-CPA frequency. A dielectric silicon resonator is embedded in the structure, which creates dipolar resonances between the resonances obtained by the formed cavity between the graphene sheet and resonator. This enhances the absorption level in the THz region. The absorption bandwidth is further enhanced to 7 THz by including a graphene disc at the top of the silicon resonator. Thus, the multiple multi-order resonances occurring in the silicon dielectric and SPR of graphene resonators are merged with the phenomena of CPA occurring in the graphene sheets to extend the CPA bandwidth in the THz regime. The doping level of graphene or its tunable Fermi energy based on the applied DC electric field provides the tunability in the total obtained absorption bandwidth. The symmetric structure provides polarization-insensitive behavior with an allowed incident angle of more than 45° with more than 90% absorption.
More Related Videos
07:38Characterization of Biological Absorption Spectra Spanning the Visible to the Short-Wave Infrared
Published on: January 10, 2025
10:35Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials
Published on: September 26, 2014
Related Concept Videos
Atomic Absorption Spectroscopy: Instrumentation
The atomizer used in AAS can be either a flame atomizer or an...
Atomic Absorption Spectroscopy: Interference
Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...
IR Spectrum
Transmittance is defined as the ratio of the radiant power passing through a sample to that from the radiation's source. Multiplying the transmittance by 100 gives the percent transmittance (%T), which varies between 100% (no absorption) and 0%...
Passive Filters
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff...
Attenuated Total Reflectance (ATR) Infrared Spectroscopy: Overview
The ATR process begins by directing a beam...
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used....