Static and dynamic diffuse wave inspection of delaminations in carbon fiber reinforced composites

This paper aims to realize a self-reference delamination inspection in CFRPs with diffuse ultrasonic waves. The static experiments are first conducted on samples with a machined defect of 0.5 mm in height which simulates an opening state delamination. The diffusivity decreases with delamination diameter (pristine, 6 mm, 12 mm) at a constant depth and increases with delamination depth (0.25 mm, 0.75 mm) at a given diameter. However, no clear pattern can be found for the dissipation coefficient because of the intrinsic absorption and manufacturing uncertainties. Both coefficients are insensitive to the delamination height under loading. In contrast, the corresponding maximum cross-correlation coefficient from coda wave interferometry shows a variation of 2.4-7 % in different samples. A sharp transition can be found due to the clapping effect when the delamination is fully closed. After then, the static loading is replaced by acoustic stressing pulse from PZT in a closed delamination sample. The low frequency pulse induced reverberation field is sampled by a high frequency diffuse wave semi-synchronously, which mimics a cyclic and low amplitude loading during service. All the dynamic cross-correlation coefficient curves present an ascending trend during voltage ramp-up due to the viscoelastic effect, no matter in the intact zone or delamination zone. When the voltage threshold of 250 V is reached, the clapping effect can be triggered. A descending trend has been found not only when the excitation is right above but also near the delamination. This can be applied as an indicator of the delamination existence regionally without scanning. Such nonlinear measurement system can be expanded to passive imaging and other deficiency inspection in CFRPs with less demanding facilities.