Optical impressions assessment for overlay restorations with rubber dam: A clinical trial

The possibility of making impressions of teeth prepared with a rubber dam in place has been proposed; however, this requires trimming and rescanning the mesh, which has been described as a cause of accuracy loss. This study aims to clinically determine whether overlay restorations obtained from a scan with a rubber dam in place have equivalent marginal fit, contact points, and occlusal fit to the same type of restorations obtained from a scan without a rubber dam.

Thirty patients who underwent overlay restoration of a molar with at least one neighbouring tooth were selected. After tooth preparation, two scans were performed: one without a rubber dam and the other with a rubber dam. Restorations were randomly created from one scan or another. The marginal fit, interproximal contact points, and occlusal fit were evaluated clinically. Two meshes, with and without rubber dams, were also compared.

No significant differences were observed in the clinical evaluation of the overlays made of the two meshes. The trueness of the mesh from the impression made with a rubber dam with respect to the mesh without a rubber dam was about 40 µm in the critical areas of the preparation (margins, intaglio, and interproximal contact points).

The results of this study show that under the conditions performed and with the equipment used, there are no significant clinical differences between overlay restorations made from a scan with a rubber dam and those made from a scan without a rubber dam.

Scanning with a rubber dam in place may be a valid option for certain types of restorations under certain clinical conditions.