Effect of Stimulus Bandwidth on the Auditory Steady-State Response in Scalp- and Ear-EEG

The auditory steady-state response (ASSR) enables hearing threshold estimation based on electroencephalography (EEG) recordings. The choice of stimulus type has an impact on both the detectability and the frequency specificity of the ASSR. Amplitude modulated pure tones provide the most frequency-specific ASSR, but responses to pure tones are weak. The ASSR can be enhanced by increasing the bandwidth of the stimulus, but this comes at the cost of a decrease in the frequency specificity of the measured response. The objective of the present study is to investigate the relationship between stimulus bandwidth and ASSR amplitude.

The amplitude of ASSR was measured for five types of stimuli: 1 kHz pure tone and band-pass noise with 1/3, 1/2, 1, and 2 octave bandwidths centered at 1 kHz. All stimuli were amplitude modulated with a 40 Hz sinusoid. Responses to all stimulus types were measured at 30, 40, and 50 dB SL. ASSRs were measured concurrently using both conventional scalp-EEG and ear-EEG.

Stimulus bandwidth and sound intensity were both found to have a significant effect on the ASSR amplitude for scalp- and ear-EEG recordings. In scalp-EEG ASSRs to all bandwidth stimuli were found to be significantly larger than ASSRs to pure tone at low sound intensity. At higher sound intensities, however, significantly larger responses were only obtained for 1- and 2-octave bandwidth stimuli. In ear-EEG, only the ASSR to 2 octave bandwidth stimulus was significantly larger than the ASSR to amplitude modulated pure tones.

At low presentation levels, even small increases in stimulus bandwidth (1/3 and 1/2 octave) improve the detectability of ASSR in scalp-EEG with little or no impact on the frequency specificity. In comparison, a larger increase in stimulus bandwidth was needed to improve the ASSR detectability in the ear-EEG recordings.