Solid mineral potential evaluation using integrated aeromagnetic and aeroradiometric datasets

The analytical hierarchy process (AHP) was employed to delineate the mineralisation potential across the notable schist belts in northwestern Nigeria. High-resolution aeromagnetic and aeroradiometric datasets were taken into consideration. This was achieved by using advanced signal enhancement techniques to study the structures, identify the hydrothermal alteration zones (that could serve as a pathway for mineralisation), and understand the geologic settings. Amongst the enhancement techniques are first vertical gradient, analytic signal, CET grid analysis and porphyry, Euler deconvolution, and K/Th ratio. The analytic signal reveals lithologic contact, structures and anomalous occurrences that aided the classification of the site into three magneto-lithologic zones: high (> 0.094 nT/m), intermediate (0.028 to 0.094 nT/m), and low magnetic zones (< 0.028 nT/m). The high magnetic zones (HMZ) were considered the main magnetic source outlines, which are inferred to be dominantly intrusive zones for hydrothermal activities. The 3-dimensional Euler deconvolution reveals highly magnetic and intrusive depth sources to be within the range of < 100 to 500 m. The Centre for Exploration Targeting (CET) grid technique revealed the structural distribution from which the lineament density map was produced. The orientations of the prevalent structural anomalies are E-W, NE-SW, WNW-ESE and NW-SE, with similar orientations observed from the first vertical gradient and the analytic signal. The highly dense structural zones coincide with the high magnetic zones and high-frequency amplitudes of the analytic signal and the vertical gradient map, respectively. Additionally, the CET porphyry detects the centres of the intrusive porphyries to be within zones of high lineament density. This reveals that the mineralisation potential of the area is structurally controlled. On the other hand, radioelement maps (eU, eTh, and K%) and ternary maps were used for lithological classification. The radiometric ternary map revealed the highly radioactive zones and the superior concentration of individual radioelements in their respective areas. The K/eTh ratio map delineates highly potassic alteration zones. The AHP model and weighted overlay tool were employed to integrate the analytic signal, lineament density, and K/Th ratio. Consequently, the mineralisation potential of the study site was revealed and classified into high, moderate, and low. This result was validated using known mine sites. There was a total agreement, with 87.5% of mines plotting within the high mineralisation potential class and 12.5% in the moderate class. Promising targets were identified for development.