Related Experiment Video
Updated: Jul 5, 2025

Generation and Coherent Control of Pulsed Quantum Frequency Combs
Published on: June 8, 2018
Comparative analysis and FPGA realization of different control synchronization approaches for chaos-based secured
Talal Bonny1, Wafaa Al Nassan1, Aceng Sambas2,3
1Department of Computer Engineering, University of Sharjah, Sharjah, United Arab Emirates.
None:
Synchronization of the chaotic systems has attracted much attention in recent years due to its vital applications in secured communication systems. In this paper, an implementation and comparative analysis of two different control approaches for synchronization between two identical four-dimensional hyperchaotic systems is presented. The two control approaches are the Adaptive nonlinear controller and the linear optimal quadratic regulator LQR. To demonstrate the effectiveness of each controller, the numerical simulation is presented using Matlab/Simulink and the control law is derived. The performance of the proposed controllers is compared based on four factors; response time, squared error integration, energy applied from the controller, and cost function. To measure the robustness of the control approaches, the performance factors are compared when there is a change in system parameters and a variation in the initial conditions. Then the proposed synchronization methods are implemented on the FPGA platform to demonstrate the utilized resources on Field Programmable Gate Array (FPGA) hardware platform and the operation speed. Finally, to generalize the results of the comparison, the study is implemented for the synchronization of another secured communication system consisting of two identical three-dimensional chaotic. The experimental results show that the LQR method is more effective than the Adaptive controller based on the performance factors we propose. Moreover, the LQR is much simpler to implement on hardware and requires fewer resources on the FPGA.
Related Concept Videos
BIBO stability of continuous and discrete -time systems
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
SFG Algebra
Each node in an SFG corresponds to a variable, and the interactions between nodes are represented by branches with associated gains. When multiple branches lead into a node, the value at that node is the sum of the...
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Comparison between RL and RC circuits

