Fabrication of translucent graded dental crown using zirconia-yttrium multi-slurry tape casting 3D printer

This paper aims to fabricate functionally graded dental crown using a multi-slurry tape casting additive manufacturing technology. The different luminescence of the dental crown was obtained with different composition of zirconia and yttria. Zirconia with tunable mechanical properties and translucency are obtained by adding 3, 3.5, 4, 4.5, and 5 mol% of yttrium oxide to zirconia powder. After obtaining the printable slurry with maximum solid loading, the green bodies are prepared using the in-house built high-speed multi-ceramic tape casting technology. They are later sintered with two-stage sintering method. After the successful fabrication, the mechanical properties and translucency of the specimens were evaluated with Vickers hardness, three-point bending and translucency parameter tests. Finally, an FGM tooth crown with five photocurable slurries is proposed to demonstrate the translucent gradient effect of sintered part. The solid loading of 80% zirconia and 20% resin delivered samples without any surface cracks. The shrinkage ratio analysis showed that the sintered sample dimension was reduced by 20%, 20%, and 23% along X, Y, and Z directions. The samples fabricated with 3% yttrium oxide to zirconia delivered excellent hardness (1687 HV) and flexural strength (650.6 MPa). However, the relative luminescence increased with increasing the yttrium oxide for 3-5 mol%. With the optimized process parameters, the proposed dental crown is fabricated and analyzed for their shrinkage ratio, mechanical, and translucency properties. The study proposes the potential of fabricating customized dental crown with gradient translucent appearance.