Assessment of the intrasinusidal volume before and after maxillary sinus augmentation using mri - a pilot study of...

The purpose of this study was to evaluate the suitability, accuracy, and reliability of a non-invasive 3-Tesla magnetic resonance imaging technique (3 T-MRI) for the visualization of maxillary sinus grafts in comparison to conventional, X-ray-based, established standard imaging techniques.

A total of eight patients with alveolar bone atrophy who required surgical sinus floor augmentation in the course of dental implantation were included in this pilot study. Alongside pre-operative cone-beam computed tomography (CBCT), 3 T-MRI was performed before and 6 months after sinus floor augmentation. Two investigators measured the maxillary sinus volume preoperatively and after bone augmentation.

In all cases, MRI demonstrated accurately the volumes of the maxillary sinus grafts. Following surgery, the bony structures suitable for an implant placement increased at an average of 4.89 cm³, corresponding with the decrease of the intrasinusidal volumes. In general, interexaminer discrepancies were low and without statistical significance.

In this preliminary study, we could demonstrate the feasibility of MRI bone volume measurement as a radiation-free alternative with comparable accuracy to CT/CBCT before procedures like sinus floor augmentation. Nevertheless, costs and artifacts, also present in MRI, have to be taken into account. Larger studies will be necessary to justify the practicability of MRI bone volume evaluation.