Concrete incorporating supplementary cementitious materials: Temporal evolution of compressive strength and...

The use of Supplementary Cementitious Materials (SCMs) or industrial wastes as a partial replacement for cement in the production of concrete is an urgent need in the construction industry due to cement's growing environmental challenges and rising cost. In respect of this, we conducted research work on proportioning binary concrete mixes. Fly ash (FA) replaced 10 %, 20 %, and 30 % of the cement, while silica fume (SF) replaced 5 %, 10 %, and 15 % of the cement. A control concrete mix was also developed with 100 % cement and no SCM. The results showed no increase in compressive strength for FA concrete compared to control at the early age of 3-28 days, but a maximum increase in compressive strength of 4 % was discovered at a later age of 56 days for concrete with 20 % FA. For 5 % SF concrete, a considerable strength increase of 15 % was seen at the early age of 3 days. Like with FA concrete, 2 % improvement in strength was recorded at the later age of 56 days for 10 % SF concrete. This study further focused on the concrete's temporal evolution of compressive strength by developing a strength evolution model (SEM) using nonlinear regression analysis at a 95 % confidence level. Pearson correlation coefficient was used to determine the correlation between the model values and the experimental results. For comparison, the fib Model Code 2010 was applied to the experimental data, and a good agreement was observed among the proposed model, the fib Model values, and the experimental results. The proposed model can be expanded to address further regression-related problems. Finally, environmental life cycle assessment revealed that utilizing 10 %, 20 %, and 30 % of FA lowered Global Warming Potential (GWP) by 9 %, 19 %, and 29 %, respectively. Likewise, using 5 %, 10 %, and 15 % of SF reduced the GWP by 5 %, 9 %, and 14 %.