Related Experiment Video
Updated: Jul 2, 2026

A Colorimetric Method for Measuring Iron Content in Plants
Published on: September 7, 2018
Measurement of Iron in Flour and Commonly-Used Breads Baked in Isfahan, Iran: A Risk Assessment Study with Monte
Zahra Esfandiari1, Roya Abdei Soleimani2, Raziyeh Eshaghi2
1Nutrition and Food Security Research Center, Department of Food Science and Technology, School of Nutrition and Food Science, Isfahan University of Medical Sciences, Isfahan, Iran. zesfandiary24@yahoo.com.
Abstract:
Fortification of highly-consumed foods such as bread is an easy and cheap strategy to combat the iron deficiency anemia. However, there have sometimes been some side effects such as iron overload and digestive problems. Accordingly, this study aimed to examine the amount of iron as well as its non-carcinogenic risks in commonly-used types of Iranian flour and breads (Barbary, Lavash, and Tafton) in Isfahan, Iran. Iron concentration of 100 samples of flour and breads were measured by Inductively Coupled Plasma Optical Emission Spectrometer. Moreover, the non-carcinogenic health risk of iron in fortified breads was estimated by Target Hazard Quotient (THQ) in Monte Carlo Simulation technique. The limit of detection (LOD) and limit of quantification (LOQ), with a recovery level of 95%, were 1.8 × 10-5 and 5.9 × 10-5 mg/kg, respectively. The total mean concentration of iron in flour (53.48 ± 22.49 mg/kg) and bread (39.02 ± 22.63 mg/kg) samples was within the standard recommended range (40-85 mg/kg) in Iran. THQ for adults and children was equal to 0.53 and 2.48. respectively. Hence, non-carcinogenic risk of iron through bread consumption was acceptable for adults, while it was not acceptable for children as a sensitive group. Consequently, it is required to rescreen the flour and bread fortification program in Iran according to the comprehensive risk assessment studies.
Related Concept Videos
Inductively Coupled Plasma-Mass Spectrometry (ICP-MS): Interferences
Fineness Modulus
Consider performing sieve analysis on sand through a set of ASTM sieves. The weight of aggregate retained in each sieve and pan placed at the bottom is recorded, as given in Column B of Table 1.
To determine the fineness modulus of...

