Drug release control and anti-inflammatory effect of biodegradable polymer surface modified by gas phase chemical...

The plasma technique has been widely used to modify the surfaces of materials. The purpose of this study was to evaluate the probability of controlling the prednisolone delivery velocity on a polylactic acid (PLA) surface modified by plasma surface treatment. Surface modification of PLA was performed at a low-pressure radio frequency under conditions of 100 W power, 50 mTorr chamber pressure, 100-200 sccm of flow rate, and Ar, O₂, and CH₄gases. The plasma surface-modified PLA was characterized using scanning emission microscope, x-ray photoelectron spectroscopy (XPS), and contact angle measurements.In vitroevaluations were performed to determine cellular response, drug release behavior, and anti-inflammatory effects. The PLA surface morphology was changed to a porous structure (with a depth of approximately 100 μm) and the surface roughness was also significantly increased. The XPS results demonstrated higher oxygenized carbon contents than those in the non-treated PLA group. The prednisolone holding capacity increased and the release was relatively prolonged in the surface-modified PLA group compared to that in the non-treated PLA group. In addition, cell migration and proliferation significantly increased after PLA treatment alone. The activity of cytokines such as cyclooxygenase-2 (COX-2), tumor necrosis factor-a (TNF-α), interleukin (IL-1β), and IL-6 were considerably reduced in the plasma-treated and prednisolone holding group. Taken together, surface-modified PLA by plasma can provide an alternative approach to conventional physicochemical approaches for sustained anti-inflammatory drug release.