Multifunctional HfAlO thin film: Ferroelectric tunnel junction and resistive random access memory

This study presents findings indicating that the ferroelectric tunnel junction (FTJ) or resistive random-access memory (RRAM) in one cell can be intentionally selected depending on the application. The HfAlO film annealed at 700 °C shows stable FTJ characteristics and can be converted into RRAM by forming a conductive filament inside the same cell, that is, the process of intentionally forming a conductive filament is the result of defect generation and redistribution, and applying compliance current prior to a hard breakdown event of the dielectric film enables subsequent RRAM operation. The converted RRAM demonstrated good memory performance. Through current-voltage fitting, it was confirmed that the two resistance states of the FTJ and RRAM had different transport mechanisms. In the RRAM, the 1/f noise power of the high-resistance state (HRS) was about ten times higher than that of the low-resistance state (LRS). This is because the noise components increase due to the additional current paths in the HRS. The 1/f noise power according to resistance states in the FTJ was exactly the opposite result from the case of the RRAM. This is because the noise component due to the Poole-Frenkel emission is added to the noise component due to the tunneling current in the LRS. In addition, we confirmed the potentiation and depression characteristics of the two devices and further evaluated the accuracy of pattern recognition through a simulation by considering a dataset from the Modified National Institute of Standards and Technology.