Atmospheric environment characteristic of severe dust storms and its impact on sulfate formation in downstream city
Related Experiment Video
Updated: Jul 2, 2025

Extraction and Characterization of Surfactants from Atmospheric Aerosols
Published on: April 21, 2017
Naixiu Sun1, Lin Wu1, Fangyuan Zheng1
1Tianjin Key Laboratory of Urban Transport Emission Research & State Environmental Protection Key Laboratory of Urban Ambient Air Particulate Matter Pollution Prevention and Control, College of Environmental Science and Engineering, Nankai University, Tianjin 300071, China.
Abstract:
This study comprehensively investigated the impact of dust storms (DSs) on downstream cities, by selecting representative DS events. In this paper, we discussed the characteristics of meteorological conditions, air pollutants, PM2.5 components, and their influence on sulfate formation mechanisms. During DSs, strong winds, reaching speeds of up to 10 m/s, led to significant increases in PM10 and PM2.5, with maximum concentrations of 2684.5 and 429 μg/m3, respectively. Primary gaseous pollutants experienced substantial reductions, with decline rates of 48.1, 34.9, 36.8, and 9.0 % for SO2, NO2, NH3, and CO, respectively. Despite a notable increase in PM2.5 concentrations, only 7.6 % of the total mass of PM2.5 was attributed to ionic and carbonaceous components, a much lower value than observed before the DSs (77.3 %). Concentrations of Fe, Ti, and Mn exhibited increases by factors of 6.5-14.1, 10.4-17.0, and 1.6-4.7, respectively. In contrast to the significant decrease of >76.2 % in nitrogen oxidation ratio (NOR), sulfur oxidation ratio (SOR) remained at a relatively high level, displaying a strong positive correlation with high concentrations of Fe, Mn, and Ti. Quantitative analysis revealed an average increase of 0.187 and 0.045 μg/m3 in sulfate from natural sources and heterogeneous generation, respectively. The heterogeneous reaction on mineral dust was closely linked to atmospheric humidity, radiation intensity, the form of metal existence, and concentrations of it. High concentrations of titanium dioxide and iron‑manganese oxides in mineral dust promoted heterogeneous oxidation of SO2 through photocatalysis during the daytime and metal ion catalysis during the nighttime. This study establishes that the metal components in mineral dust promote heterogeneous sulfate formation, quantifies the yield of sulfate generated as a result, and provides possible mechanisms for heterogeneous sulfate formation.
More Related Videos
07:47Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
10:22Split Point Analysis and Uncertainty Quantification of Thermal-Optical Organic/Elemental Carbon Measurements
Published on: September 7, 2019
Related Concept Videos
The Sulfur Cycle
Sulfate Attack on Concrete
Sulfates from sources like soil, groundwater, or industrial effluents...
Electrophilic Aromatic Substitution: Sulfonation of Benzene
What is Weather?
Asthma-I: Introduction
Atomic Absorption Spectroscopy: Atomization Methods