Related Experiment Video
Updated: Jul 2, 2025

Pore-scale Imaging and Characterization of Hydrocarbon Reservoir Rock Wettability at Subsurface Conditions Using X-ray Microtomography
Published on: October 21, 2018
Experimental Performance Evaluation and Optimization of a Weak Gel Deep-Profile Control System for Sandstone
Kazunori Abe1, Khwaja Naweed Seddiqi2, Jirui Hou3
1Department of Earth Resource Engineering and Environmental Science, Akita University, Graduate School of International Resource Sciences, 1-1 Tegata Gakuen-machi, Akita 010-8502, Japan.
Abstract:
Globally, most oil fields use excessive water flooding to recover oil. By injection of water between wells, channels are created, which result in lower oil recovery. Water-plugging deep-profile control must be used to control the excessive water production from an oil reservoir. This laboratory study used sulfonated polyacrylamides with a molecular weight of 10.3-13.0 × 106 Da (FPAM) and polyethylenimine (PEI-600) to formulate a weak gel system to control excessive water production from deep formations. Using different FPAM and PEI-600 concentrations, the Sydansk bottle test approach was applied to evaluate the gelation time, strength, and stability of the weak gel. The weak gel concentration of 0.5 wt % FPAM and 0.4 wt % PEI-600 was confirmed for deep-profile control by this approach. The temperature and salt resistance of the selected weak gel system were evaluated using the same bottle test methodology. The gelation time depends on temperature: 5-7 days at <100 °C to 0.5 days >100 °C. Salinity >20,000 mg/L significantly affected the weak gel system's strength. By performing a viscometer test, the viscosity of the weak gel system at different times was evaluated, confirming the gelation time of the selected weak gel. Next, a microfluidic chip flooding test analyzed weak gel performance and plugging ability in porous media. This micromodel provided a visual analysis of the weak gel plug. Finally, a low- to medium-permeability sandstone core-flooding was conducted to determine the plugging rate of weak gel at the core scale, followed by an evaluation of the injection pressure, blocking effect, and oil recovery. According to the study, the selected weak gel has an extended gelation time with a significantly low viscosity, which affects its injectivity and can move from injection wells into deep formations. In the core-flooding test, the weak gel's blocking rate after 7 days of gelation time exceeded 90%.
Related Concept Videos
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Design Example: Managing Concrete Workability
Porosity in Cement Paste
The balance of water to cement in the mix is...

