In-person versus electronic screening for social risks among carers of pediatric inpatients: A mixed methods

Lisa Gaye Smithers1,2, Catherine MacPhail3, Lily Chan4

  • 1School of Health and Society, University of Wollongong, Northfields Road, Wollongong, NSW, 2522, Australia. lsmithers@uow.edu.au.

PubMed

Related Concept Videos

Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between the two are due to...
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which child was...
What is an Experiment?01:12

What is an Experiment?

An experiment is a planned activity carried out under controlled conditions. The purpose of an experiment is to investigate the relationship between two variables. When one variable causes change in another, we call the first variable the explanatory or independent variable. The affected variable is called the response or dependent variable. In a randomized experiment, the researcher manipulates values of the explanatory variable and measures the resulting changes in the response variable. The...
Randomized Experiments01:13

Randomized Experiments

The randomization process involves assigning study participants randomly to experimental or control groups based on their probability of being equally assigned. Randomization is meant to eliminate selection bias and balance known and unknown confounding factors so that the control group is similar to the treatment group as much as possible. A computer program and a random number generator can be used to assign participants to groups in a way that minimizes bias.
Simple randomization
Simple...
Cochran's Q Test01:17

Cochran's Q Test

Cochran's Q Test is a nonparametric statistical test used to determine if there are potential differences in the outcomes of three or more related groups on a binary (yes/no) or dichotomous outcome. It is essentially an extension of the McNemar Test, which is limited to two related samples - Cochran's Q test can handle three or more related samples, making it more versatile in scenarios where subjects are measured under multiple conditions. The test statistic follows a Chi-Square distribution,...
Hazard Ratio01:12

Hazard Ratio

The hazard ratio (HR) is a widely used measure in clinical trials to compare the risk of events, such as death or disease recurrence, between two groups over time. It reflects the ratio of hazard rates—the instantaneous risk of the event occurring—between a treatment group and a control group. This measure provides valuable insights into the relative effectiveness of a treatment by assessing how the risk of an event differs between the two groups.
For example, in a clinical trial evaluating a...