Snow Contamination by Metals and Metalloids in a Polar Town: A Case Study of Nadym, Russia
D V Moskovchenko1,2, R Y Pozhitkov3, A V Soromotin4
1Tyumen Scientific Centre, Siberian Branch of the Russian Academy of Sciences, Malygina St., 86, 625026, Tyumen, Russia. moskovchenko1965@gmail.com.
Abstract:
Snow composition depends on the long-range transport of pollutants. This article examines aspects of snow composition in the town of Nadym in Western Siberia. During fieldwork conducted in 2021 and 2022, we determined dust load, concentrations and ratio of dissolved and suspended forms of metals and metalloids (MMs). Moreover, we analyzed air mass trajectories using the HYSPLIT model, and the results showed that industrial regions of the southern Urals, southeastern Siberia, and Kazakhstan were the sources of MMs. Content of the insoluble fraction was increased by 23-fold in Nadym. The dust load in Nadym was higher than that in urban communities situated in the temperate zone, even though this town is relatively small in population and has little industrial infrastructure. This significant increase in dust load led to a ten- to 100-fold increase in the content MMs. Local soils (Fe, Al), vehicles (W), building dust (Mg, Ca), and anti-icing agents (Na) were found to be the sources of pollution. We found that the high dust load is caused by meteorological factors, such as temperature inversion and a large number of calm days, which reduce the dispersion of pollution. This case study demonstrates that winter air quality in polar settlements can be worse than that in urban areas in the temperate zone, even with few local sources of pollution. Furthermore, the trend toward an increase in the number of windless days, such as observed in Siberia as a result of global climate change, increases the risk of anthropogenic pollution of the atmosphere of polar cities.
Related Concept Videos
Precipitation Gravimetry
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Precipitation and Co-precipitation
Types of Coprecipitation
Sometimes, ions in a crystal lattice can undergo isomorphous replacement by inclusions of similar charge and size. For...
Electrodeposition
Electrodeposition can...
Colloidal precipitates


