Related Experiment Video
Updated: Jul 1, 2025

Finite Element Modeling for the Simulation of the Quasi-Static Compression of Corrugated Tapered Tubes
Published on: January 6, 2023
Numerical analyses for three-dimensional face stability of circular tunnels in purely cohesive soils with linearly
Bing Huang1,2, Daidai Yu2, Yinting Zhao2
1Sichuan Expressway Construction and Development Group Co., Ltd, Chengdu, 610031, China.
Abstract:
The tunnel face stability in purely cohesive soils with linearly increasing strength was investigated using three-dimensional finite element limit analysis (FELA). Both the collapse (active failure) and blow-out (passive failure) of the tunnel face were considered in the analysis. The rigorous upper bound (UB) and lower bound (LB) solutions of the load factor were calculated with a wide range of ground conditions to cover a broad scope of practical application. The results showed that the whole surface of the face is at failure in the collapse case; while in the blow-out case, there exists a gradual evolution process from partial failure to global failure within the tunnel face with increasing buried depth. Later, based on 960 finite element limit analysis results, a series of practical equations were proposed for tunnel face stability analysis in purely cohesive soils. These equations can be employed to quickly calculate the UB and LB solutions of the limit support pressure and the stability number of a tunnel face in both the collapse and blow-out cases. Finally, the calculation results from these equations were compared with those from previous studies in detail. The comparisons showed that the proposed equations make an improvement over existing methods and can be used as an efficient tool in practical engineering.
More Related Videos
Related Concept Videos
Three-Dimensional Analysis of Strain
Stress Concentrations in Circular Shafts
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Thin-Walled Hollow Shafts
Deformations in a Symmetric Member in Bending
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
Torsion of Noncircular Members

