Related Experiment Video
Updated: Jun 30, 2025
Impact of Fabrication Techniques and Polishing Procedures on Surface Roughness of Denture Base Resins
Published on: January 17, 2025
Accuracy of Dental Restorations Fabricated Using Milling vs 3D-Printed Molds: A Pilot Study
Purpose:
To compare the accuracy of 12 different dental restorations fabricated with milling or 3D-printed molds and robotically controlled casting.
Materials And Methods:
Twelve dental restorations (11 inlays and onlays and 1 crown) were made per restoration type, one per each of the 12 different teeth models (total of 24 restorations). On each tooth preparation, two restorations were manufactured using different CAD/ CAM techniques: (1) milling and (2) robotically controlled casting and 3D-printed molds. In addition, twolayer restorations were manufactured with 3D-printed molds. The marginal and internal gaps were evaluated at 120 points per restoration based on micro-CT 3D imaging. Internal gaps were evaluated using a replica technique with silicone.
Results:
Median values (interquartile ranges) for marginal gaps, middle internal gaps, and central internal gaps were significantly lower for 3D-printed mold restorations (44.3 [65.4] μm, 95.4 [96.2] μm, and 104.6 [78.1] μm) compared to milled restorations (58.4 [93] μm, 145.9 [85.8] μm, and 138.6 [65.7] μm). Internal gaps in the 3D-printed mold group were 6% to 51% smaller than in the milled group.
Conclusions:
The accuracy of restorations fabricated with 3D-printed molds may be preferable compared to milled restorations, except in the case of crown restoration. However, additional studies with a larger number of samples and different types of restorations are needed to confirm the results.
