Related Experiment Video
Updated: May 3, 2026

Using Tomoauto: A Protocol for High-throughput Automated Cryo-electron Tomography
Published on: January 30, 2016
High-resolution co-seismic fault offsets of the 2023 Türkiye earthquake ruptures using satellite imagery
Floriane Provost1,2, Volkan Karabacak3, Jean-Philippe Malet4,5
1Ecole et Observatoire des Sciences de la Terre (EOST), CNRS UAR 830, Université de Strasbourg, 5 rue René Descartes, 67084, Strasbourg, France. f.provost@unistra.fr.
Abstract:
On February 6, 2023, southern Türkiye was struck by two large earthquakes at 01:17 UTC (Mw=7.8, Pazarcık, Kahramanmaraş) and 10:30 UTC (Mw = 7.6, Elbistan, Kahramanmaraş), causing severe damage at the complex junction of the Dead Sea Fault (DSF), the Cyprus Arc and the East Anatolian Fault Zone (EAFZ). The ruptures propagated along several known strands of the southwestern termination of the EAFZ, the main Pazarcık and Karasu valley faults, and the Çardak-Sürgü fault. Here we present the high-resolution mapping of the entire coseismic surface rupture and an estimate of the rupture width, total and on-fault offset, and diffuse deformation obtained a few days to three months after the two mainshocks. The mapping is derived from image correlation of Sentinel-2 optical satellite imagery and validated with offset measurements collected on the ground. We find that the ruptures extend over lengths of 310 km and 140 km for the Mw 7.8 and Mw 7.6 mainshocks, respectively. The maximum offsets reach 7.5 ± 0.8 m and 8.7 ± 0.8 m near the epicenters of the Mw 7.8 and Mw 7.6 events, respectively. We propose a segmentation of the two ruptures based on these observations, and further discuss the location of the potential supershear rupture. The use of optical image correlation, complemented by field investigations along earthquake faults, provides new insights into seismic hazard assessment.
More Related Videos
06:55Kinematic History of a Salient-recess Junction Explored through a Combined Approach of Field Data and Analog Sandbox Modeling
Published on: August 5, 2016
07:58Data Processing Methods for 3D Seismic Imaging of Subsurface Volcanoes: Applications to the Tarim Flood Basalt
Published on: August 7, 2017
Related Concept Videos
Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
Precipitation Gravimetry
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
Influence of Earth's Curvature and Atmospheric Refraction on Leveling
Plotting of Topographic Maps
Errors in Global Positioning System
Design Example: Identifying the Locations of Monuments in the Field Using Global Positioning System Device