Related Experiment Video
Updated: May 13, 2026
Treatment of Ankle Osteoarthritis with Total Ankle Replacement Through a Lateral Transfibular Approach
Published on: January 24, 2018
Effect of a compression staple on correction of varus deformity during arthroscopic ankle arthrodesis
Tomoyuki Nakasa1, Yasunari Ikuta2, Shingo Kawabata2
1Department of Artificial Joints and Biomaterials, Graduate School of Biomedical and Health Sciences, Hiroshima University, Hiroshima, Japan.
Background:
Arthroscopic ankle arthrodesis (AAA) has become popular because of its higher rate of bone union, lower invasiveness, and shorter hospital stays compared to those of open arthrodesis. However, postoperative malalignment is often observed for severe varus deformity, which can cause nonunion, pain, and adjacent joint arthrosis. A compression staple can provide a persistent, strong compressive force on the bone surface. This study aimed to clarify the difference in alignment correction in AAA by comparing a compression staple and screws fixation with screws-only fixation pre- and postoperatively.
Methods:
Seventy ankles in 67 patients undergoing AAA were retrospectively reviewed. AAA with three screws through the distal tibia was performed in 53 ankles, and 17 ankles underwent AAA with a compression staple and two screws. After the preparation of the joint surface arthroscopically, patients in the S group had three canulated cancellous screws inserted through the medial tibia. Patients in the CS group had a compression staple placed at the lateral aspect of the tibiotalar joint and two screws inserted through the medial side. Clinical scores and pre-and postoperative alignment on plain radiographs were compared between the two procedures.
Results:
There were no significant differences in the pre-and postoperative Japanese Society for Surgery of the Foot scale. One ankle in the S group exhibited nonunion. There were no significant differences in talar tilt and tibiotalar angles between the groups. The tibial plafond angle in the CS group was significantly lower than that in the S group (p < 0.05). Postoperatively, talar tilt and tibiotalar angles on the coronal image, and the lateral tibiotalar angle in the CS group were significantly lower than those in the S group (p < 0.05).
Conclusion:
AAA with a compression staple and two-screw fixations could obtain more optimal alignments than AAA with screw-only fixation, even in cases with severe varus deformity.
More Related Videos
05:34A Mini-Invasive Internal Fixation Technique for Studying Immobilization-Induced Knee Flexion Contracture in Rats
Published on: May 20, 2019
04:19Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
