Constrained and Open Mesoporosity in Polypropylene Cracking: Insight From Spectroscopic Investigations of Acidity,...

The outcome of the demetalation process of zeolites depends on applied treatment conditions and can lead to the formation of either open or constrained mesopores. The quaternary ammonium cations as pore-directing agents during desilication are responsible for developing constrained mesoporosity with bottleneck entrances. However, higher mesopore surface area and higher accessibility of acid sites are often found for the hierarchical zeolites with constrained mesopores. This is followed by better catalytic activity in the cracking of vacuum gas oil and polymers. For desilication with pure NaOH, a realumination process is observed and an additional acid-wash step is required to reach their full catalytic potential. Thus, this study aims to analyze the acidic and catalytic properties of hierarchical ZSM-5 zeolites of different mesoporosity types employing in situ and operando FT-IR spectroscopic evaluation of polypropylene cracking. The suitability of constrained mesoporosity is studied by assessing the neopentane diffusion in kinetic adsorption, Monte Carlo calculations, and rapid scan FT-IR spectroscopic measurement analyzed by Crank solution for diffusion. The FT-IR spectroscopic results of in situ and operando studies are supported by two-dimensional correlation analysis, allowing to establish the direction of changes seen on spectra and their order.