Related Experiment Video
Updated: Jun 29, 2025
Impact of Fabrication Techniques and Polishing Procedures on Surface Roughness of Denture Base Resins
Published on: January 17, 2025
Development of an antimicrobial, 3D printable denture base material with K18 quaternary ammonium
Mansi Patel1, Leslie Barrera2, Lianrui Chu3
1Undergraduate student and Researcher, Department of Comprehensive Dentistry, University of Texas Health Science Center at San Antonio, San Antonio, Texas.
Statement Of Problem:
Denture base materials are highly susceptible to microbial colonization, which can lead to denture stomatitis. In addition, patients who sleep with their dentures have an increased chance of contracting pneumonia. Commercially available antimicrobial denture base materials to prevent or combat microbial colonization are lacking.
Purpose:
The purpose of this in vitro study was to determine the effects of K18 quaternary ammonium methacryloxy silane-functionalized filler (K18-Filler) and methyl methacrylate (K18-MMA) on the polymerization of 3D printed denture base material and its esthetic, mechanical, and antimicrobial properties.
Material And Methods:
K18-Filler (0%, 10%, 20% w/w) and K18-MMA (0%, 5%, 12.5% w/w) were added to a 3D printable denture base resin (Denture Base Resin, Original Pink; Formlabs Inc) and 3D printed. Specimens were tested by using the Rockwell15T hardness, near infrared FTIR monomer-to-polymer degree of conversion (DoC), transparency parameter (TP), color shift, and 3-point bend and by counting colony forming units against Streptococcus aureus, Streptococcus sanguinis and Candida albicans tests. Data were analyzed using analysis of variance with the Tukey-Kramer HSD post hoc test.
Results:
Control resins had significantly higher Rockwell15T hardness than most of the K18 groups (P<.05) but had comparable DoC with all K18 groups except one, showing that all groups were well polymerized. Controls had significantly higher TP than most K18 groups, but most K18 groups had ΔE<3.3, so the color shift was not noticeable. However, the 12.5% K18-MMA with 10% and 20% K18-Filler groups, which were also the groups used to test for antimicrobial activity, had ΔE>8. All K18 groups had comparable or greater moduli than the controls, but the controls had significantly higher ultimate transverse strengths than most K18 groups (P<.05). All 12.5% K18-MMA with K18-Filler groups had significant antimicrobial activity against S. aureus, S. sanguinis, and C. albicans.
Conclusions:
12.5% K18-MMA and K18-Filler produced 3D printable denture materials with comparable polymerization properties and significant antimicrobial properties against S. mutans, S. sanguinis, and C. albicans. High K18-MMA and K18-Filler concentrations caused significant color shifts and reductions in ultimate strengths.
